Ich habe soeben ein neues, drittes Ethernet-Kabel verwendet. Seine Stecker sitzen nach dem Einschnappen auf beiden Seiten satt in den Buchsen. Normalerweise würde ich erwarten, dass das LAN nun vom WLAN übernimmt, das tritt aber nicht ein. Wenn ich darauf das WLAN ausschalte, verliere ich jede Internetverbindung.
Hier ein wenig Diagnostik unter Linux:
anark@ark:~$ sudo lshw -class network -short
[sudo] password for anark:
H/W path Device Class Description
/0/100/1c.6/0 wlp4s0 network Wireless 8265 / 8275
/0/100/1f.6 enp0s31f6 network Ethernet Connection (4) I219-V
anark@ark:~$ ip a s enp0s31f6
2: enp0s31f6: <NO-CARRIER,BROADCAST,MULTICAST,UP> mtu 1500 qdisc fq_codel state DOWN group default qlen 1000
link/ether c8:5b:76:d4:a7:12 brd ff:ff:ff:ff:ff:ff
anark@ark:~$ sudo ethtool enp0s31f6
Settings for enp0s31f6:
Supported ports: [ TP ]
Supported link modes: 10baseT/Half 10baseT/Full
100baseT/Half 100baseT/Full
1000baseT/Full
Supported pause frame use: No
Supports auto-negotiation: Yes
Supported FEC modes: Not reported
Advertised link modes: 10baseT/Half 10baseT/Full
100baseT/Half 100baseT/Full
1000baseT/Full
Advertised pause frame use: No
Advertised auto-negotiation: Yes
Advertised FEC modes: Not reported
Speed: Unknown!
Duplex: Unknown! (255)
Port: Twisted Pair
PHYAD: 2
Transceiver: internal
Auto-negotiation: on
MDI-X: Unknown (auto)
Supports Wake-on: pumbg
Wake-on: g
Current message level: 0×00000007 (7)
drv probe link
Link detected: no
anark@ark:~$
Unter Settings > Network > Wired sehe ich:
Hardware address: C8:5B:76😀4:A7:12
Last used: Today
✓ Connect automatically
✓ Make available to other users
Das ist ziemlich schräg, weil die hier ausgewiesene Geräte-Adresse, C8:5B:76😀4:A7:12, nicht mit der MAC Adresse übereinstimmt, die auf dem Gerät angeschrieben ist.