Electroren Daniele, I have always been Ipv4, as I told you, and even sent an screen copy showing the port forwarding features. The problem is that the port always shows “closed” when I test it. See screen copy attached. Can you help or not? Thank you Renaud
Daniele_Sunrise @BoredEngineer , Welcome to the Community! We have changed your modem to IPv4. If you don’t have the port forwarding features, please restart your modem. Greetings Daniele
Daniele_Sunrise @Electroren , Your modem has already been switched to IPv4. If you don’t have the features, please restart your modem. Greetings Daniele
Electroren Hello Ahmet, Sorry for the delay, I was in vacation. My customer Nr is: xxxxx (Edited by Mod) Best regards Renaud
Nicolate Hi Daniele, Could you please also set my box to IPv4? I need Port forwarding but haven’t found any ways to switch by myself
Daniele_Sunrise @Electroren ,Can your Arduino WIFI module communicate externally? Is it connected to the Connect Box via WIFI and can you access your module via internal IP? Greteings Daniele
Electroren Hello Daniele, This is an arduino ESP8266 wifi module that I have programmed miself. It just shown an HTML page with datas it measures from my heating system and that I whant to consult from abroad. Thank you, Best regards Renaud
Daniele_Sunrise @Electroren , You are redirecting this port to 192.168.0.66. What kind of WIFI device is the IP 192.168.0.66? It looks like a router. If you run a router with this IP, you have a double NAT in use, which can lead to problems. Please describe exactly what you want to do with the port forwarding. Greetings Daniele
Ahmet_sunrise Hi @pemko. Your modem has been changed to IPv4. @user030695 Please sent us a DM with your customer number. We would like to help you out. Cheers, Ahmet
pemko Hey can you please set me also to IPv4. I need Port forwarding. Sadly the UPnP doesn’t work correctly, so I need to use the port forwarding
Daniele_Sunrise @Electroren ,Please upload a screenshot so we can see the settings. I’ll test it afterwards and get back to you. Greetings Daniele
Electroren Hello Daniele, My connect box has ipv4, I have setup 1 port for port forwarding, but checking it with a port check tool, it looks closed. Am I missing anything? Thank you, Renaud